Dihr LP2 SHR PLUS - Front Loading Pot and Utensil Washer 700 x 700 Rack with Heat Recovery

Dihr LP2 SHR PLUS - Front Loading Pot and Utensil Washer 700 x 700 Rack with Heat Recovery

The Dihr LP2 SHR PLUS combines a large 700 x 700mm front loading pot washer with a heat recovery system, for busy kitchens that want to reduce steam and energy use. The HR unit recovers about 3.5 kWh per hour, and Scots Ice says it brings humidity volume down by roughly 20%. It is the heat recovery version of the LP2 S PLUS, with longer cycles of 4 to 13 minutes and a taller 2140mm body.

Key features:

• Heat recovery (HR) system, recovering about 3.5 kWh per hour (Dihr figure, based on the shortest cycle)
• Reduces humidity volume by approximately 20% (Scots Ice)
• 700 x 700mm rack with up to 645mm of tray height
• 4 wash cycles of 4, 7, 10 and 13 minutes
• 4.3 litres of water per cycle, rinsing at 85°C
• Two 1750 W wash pumps plus a separate rinse pump
• 5 inch TFT touch display
• Double-skin construction, deep-formed tank and double tank filter with dirt collection
• Supplied with a basket, tray support and spatula basket

Specifications:

• Model: Dihr LP2 SHR PLUS
• Rack size: 700 x 700mm, maximum tray height 645mm
• Dimensions: 840 W x 885 D x 2140 H mm (including the heat recovery unit)
• Weight: 218 kg
• Output with 10°C water: 15 / 8 / 6 / 4 racks per hour
• Water use: 4.3 litres per cycle
• Boiler: 15 litres, 9 kW, rinse set at 85°C; wash tank 82 litres at 55°C
• Power: 12.5 kW, 400V three phase plus neutral, 50Hz
• Water connection: 3/4 inch, inlet pressure 200–400 kPa; drain pipe 32–40mm
• Water quality: hardness below 8 °F, conductivity above 200 µS/cm
• Made in Italy

Good to know before you buy:

• Cold water: Scots Ice states this model requires a cold water connection, which the heat recovery system uses. The Dihr spec sheet also shows a hot water inlet, so have your licensed plumber follow the spec sheet. Dihr notes it is not for reverse-osmosis (osmotic) water.
• Power: 12.5 kW on 400V three phase. It must be connected by a licensed electrician. We supply the equipment only.
• Height: 2140mm tall with the HR unit, so check your ceiling height and overhead fittings.
• Access: at 218 kg it is delivered by tailgate truck to the front of your premises. Check doorways and plan how you will move it inside.

Compare similar models:

• Dihr LP2 S PLUS: same rack without heat recovery, 1790mm high
• Dihr LP1 S8 HR PLUS: narrower heat recovery model with 805mm tray height
• Dihr LP3 SHR PLUS: wider 850 x 725mm rack with heat recovery
• Dihr LP4 S8 HR PLUS: largest 1350 x 725mm rack with heat recovery

Common questions:

What does SHR mean?
It is the heat recovery (HR) version of the LP2 S PLUS. The HR unit on top captures heat and reduces the steam released into the kitchen.

Is it better for a kitchen with poor ventilation?
Scots Ice rates the HR system as cutting humidity volume by about 20%, which helps. Your ventilation still needs to meet local rules, so check with your mechanical ventilation contractor.

Do you install it?
We supply the equipment only. It must be connected by a licensed electrician and a licensed plumber in your area.

See all our commercial utensil and pot washers.

Warranty: 2 years parts and 2 years labour (24 months each) through Dihr's Australian distributor, Scots Ice. Exclusions apply.