Norris BT700 AWC - Upright Passthrough Dishwasher

Norris BT700 AWC - Upright Passthrough Dishwasher

The Norris BT700 AWC is an Australian-made, three-phase pass-through dishwasher from Norris's Advanced Wash Control range, for restaurants and cafes that need more output than a single-phase machine. It washes up to about 700 plates an hour, with short cycles for glassware and plates, a longer cycle for pots and a manual cycle for baked-on soil. It sits between the 15 amp BT600 and the larger BT2000, and Norris's newer FI 700 is built on the same footprint.

Key features:

• Up to about 700 plates per hour (depending on incoming water temperature and pressure)
• Norris Advanced Wash Control (AWC) electronic controller
• Glass, plate and pot cycles plus a manual cycle
• Automatic detergent and rinse aid dosing
• Recirculating wash system with a quick-recovery boiler
• Corner or in-line positioning
• Optional drain pump
• Made in Australia by Norris

Specifications:

• Model: Norris BT700 AWC
• Footprint: the same as the Norris FI 700 (595 W x 633 D mm cabinet, per Norris)
• Height: about 1400–1450 mm
• Power: three phase
• Water connection: 1/2 inch BSP hot water tap, hot water held at 50–65°C, 10 L/min at 200–400 kPa
• Drain: drain connection within 1 metre; drain pump optional

Good to know before you buy:

• Power: it runs on three-phase power and must be connected by a licensed electrician, who should size the supply from the Norris installation manual. We supply the equipment only.
• Water and drain: it needs a hot water system that can hold 50–65°C at the machine, plus a drain within 1 metre, connected by a licensed plumber.
• Ordering: this model is built to order by Norris and is no longer shown on Norris's current website. Contact us and we will confirm the current specification before you buy.

Compare similar models:

• Norris BT600 AWC: single-phase 15 amp version, up to 600 plates per hour
• Norris BT2000 AWC: larger three-phase model, up to about 1080 plates per hour
• Norris FI 700: electromechanical model on the same footprint, connects to cold water
• Norris Madison IM7: imported pass-through, up to 700 plates per hour

Common questions:

BT700 or FI 700?
Both are Australian-made and share the same footprint. The BT700 uses Norris's AWC electronic controller and a hot water supply; the FI 700 is electromechanical and connects to cold water.

Does it need hot water?
Yes. Norris's manual calls for a hot water system holding 50–65°C at the dishwasher.

Do you install it?
We supply the equipment only. It must be connected by a licensed electrician and a licensed plumber in your area.

See all our commercial upright dishwashers.

Warranty: 2 years parts and labour, plus 5 years on the AWC control board, from Norris. Exclusions apply. We will confirm the current warranty terms with Norris when you order.